GE LOGIQ E10, Basic Service Manual

Page: 252 / 778

D
IRECTION
5750007-1EN, R
EV
. 1 LOGIQ E10 B
ASIC
S
ERVICE
M
ANUAL
8 - 6 Section 8-2 - Warnings and important information
8-2-5 Tools needed for servicing the LOGIQ E10
The following tools are needed to service the LOGIQ E10. If the torque is not indicated with the
procedure, hand tighten the screws/nuts.
8-2-6 PPE Required During Service
The following PPE are required during service tasks, per EHS Policy:
Table 8-3 Tools used for servicing LOGIQ E10
TOOL TYPE TOOL SIZE
TORX
BIT # TX-2.8
BIT # TX-10
BIT # TX-15
BIT # TX-20
BIT # TX-25
BIT # TX-30*
BIT # TX-45*
FLAT BLADE
SCREWDRIVER
1/4 inch or 6 mm
PHILLIPS SCREWDRIVER
PH1
PH2 and PH2 “Stubby"
PH3
NUT DRIVER 7 mm, 10 inches long
HEX WRENCH
3 mm
4 mm
5 mm
6 mm
8 mm
10 mm
OPEN END WRENCH
TORQUE WRE
5 mm
10 mm
13 mm
3/16 inch
Up to 81 Nm (59.7 lbf-ft)**
ADJUSTABLE WRENCH 152 mm (6 inches) long
PRY BAR approximately 18 inches overall (457 mm)
* 90 degree “L“ is suggested. A full set of 90 degree “L“ Torx wrenches are recommended.
** Heavy mechanical parts may need a specific torque. Each procedure will indicate the torque needed.
PPE Required During Service
• Safety Glasses
• Safety Shoes
• Cut Resistant Gloves
• Kneel pad (if kneeling is required)
• An ESD - mat and wrist strap