GE LOGIQ A100, Technical Publication

Page: 221 / 408

OB Report Page
205
LOGIQ
t α
100 User Manual
2211157–100 Rev 0
Editing the Measurement Averaging Page
Edit the Measurement Averaging Page in the same
manner as the OB Report Page. Use the
TRACKBALL,
SHIFT
z"#!
or RETURN keys. Only USE fields can be
edited. Measurements displayed on the report cannot be
edited. However, if ‘N’ or ‘D’ is entered in the USE field,
this could exclude or delete specific measurements.
Average All
The default state for the measurement USE fields is
selected by the “AVERAGE ALL” field. The “AVERAGE
ALL” field is non-volatile and will be remembered even
after power down.
If the “AVERAGE ALL” field is ‘N’ (no) then the default for
the current measurement is ‘Y’ (yes) and the two prior
measurements will be ‘N’. ‘N’ is the factory and service
default setting for the AVERAGE ALL field. If the
Measurement Averaging Page is never used, the
AVERAGE ALL selection is likely to be ‘N’ (no).
If the AVERAGE ALL field is set to ‘Y’, the default for all
measurement USE fields will be ‘Y’. It is assumed that all
measurements (up to three) will be averaged as a matter
of regular procedure.