GE LOGIQ 7, Basic User Manual

Page: 514 / 984

OB/GYN
9
-
96 LOGIQ 7 Basic User Manual
Direction 2392206-100 Rev. 1
Uterus length, width, and height
Each of these is a standard distance measurement. Typically,
length and height are measured on the saggital plane while the
width is measured on the axial/transverse plane.
To measure uterus length, width, or height:
1. Scan the patient in the appropriate scan plane.
2. Select
the UT folder, then select UT L , UT W , or UT H .
An active caliper displays.
3. Perform a standard distance measurement:
a. To position the active caliper at the start point, move the
Trackball .
b. To fix the start point, press Set .
The system fixes the first caliper and displays a second
active caliper.
c. To position the second active caliper at the end point,
move the Trackball .
A dotted line connects the measurement points.
d. To complete the measurement, press Set .
The system displays the distance value in the Results
Window. After the first and second measurement, the
system displays an active caliper for the next
measurement.
4. To make the second and third distance measurement,
repeat steps 2–3.
After you complete the third distance measurement, the
system displays the uterine volume in the Results Window.