GE L60, Instruction Manual, Page: 17 / 498

GE Multilin L60 Line Phase Comparison Relay 1-7
1 GETTING STARTED 1.3 ENERVISTA UR SETUP SOFTWARE
1
10. Click Finish to end the installation. The L60 device will be added to the list of installed IEDs in the enerVista Launch-
pad window, as shown below.
1.3.3 CONNECTING ENERVISTA UR SETUP WITH THE L60
This section is intended as a quick start guide to using the enerVista UR Setup software. Please refer to the enerVista UR
Setup Help File and Chapter 4 of this manual for more information.
a) CONFIGURING AN ETHERNET CONNECTION
Before starting, verify that the Ethernet network cable is properly connected to the Ethernet port on the back of the relay. To
setup the relay for Ethernet communications, it will be necessary to define a Site, then add the relay as a Device at that site.
1. Install and start the latest version of the enerVista UR Setup software (available from the GE enerVista CD or online
from
http://www.GEindustrial.com/multilin (see previous section for installation instructions).
2. Select the “UR” device from the enerVista Launchpad to start enerVista UR Setup.
3. Click the Device Setup button to open the Device Setup window, then click the Add Site button to define a new site.
4. Enter the desired site name in the “Site Name” field. If desired, a short description of site can also be entered along
with the display order of devices defined for the site. Click the
OK button when complete.
5. The new site will appear in the upper-left list in the enerVista UR Setup window. Click on the new site name and then
click the
Device Setup button to re-open the Device Setup window.
6. Click the Add Device button to define the new device.
7. Enter the desired name in the “Device Name” field and a description (optional) of the site.
8. Select “Ethernet” from the Interface drop-down list. This will display a number of interface parameters that must be
entered for proper Ethernet functionality.
• Enter the relay IP address (from
SETTINGS PRODUCT SETUP COMMUNICATIONS NETWORK IP ADDRESS
)
in the “IP Address” field.
• Enter the relay Modbus address (from the
PRODUCT SETUP COMMUNICATIONS MODBUS PROTOCOL MOD-
BUS SLAVE ADDRESS
setting) in the “Slave Address” field.
• Enter the Modbus port address (from the
PRODUCT SETUP COMMUNICATIONS MODBUS PROTOCOL
MODBUS TCP PORT NUMBER
setting) in the “Modbus Port” field.
9. Click the Read Order Code button to connect to the UR device and upload the order code. If an communications error
occurs, ensure that the three enerVista UR Setup values entered in the previous step correspond to the relay setting
values.