GE JXDD43, User Manual

Page: 9 / 36

Gas Burner Controls
See Gas Burner Component
instructions on pages 16 and 17.
Note the caution and cookware
advisory on page 17.
The gas burner controls must turn
counterclockwise to the
position to ignite the burner. Once
the burner is ignited, turn the
control knob counterclockwise to
adjust the flame lower. A sparking
sound caused by the igniter is
normal until ignition occurs.
See Grill Component
Controls
instructions on pages 18 and 19.
The Grill Cooking Guide is on
page 20. See Griddle Accessory
information on pages 21 and 22.
The Griddle Cooking Guide is
on page 23.
Most cooking on the grill or
griddle is done at the HI setting.
See page 18 regarding flame-ups
and the control settings for this
emergency.
Vent System Control
To operate the vent system
manually, turn the knob on the
control panel clockwise to the
desired blower speed.
Use the control knob at the front of
the vent grille to adjust blower
speed. The control knob may be in
a custom location in the counter
cabinet front. A HI setting is
recommended when flame-ups
occur while cooking on the grill.
The burners will relight at any
setting. However, for the burners
to light quickly and consistently
when the gas is turned on, the
knobs should be turned to the
position until ignition
occurs.
When turning the control knob to
off (0), turn it clockwise.
Each half of the grill component is
controlled separately.
The control knob labeled
GRIDDLE controls the entire
griddle accessory.
The GRILL/GRIDDLE controls
turn either direction to adjust the
heat setting.
The downdraft blower adjacent to
the grill comes on automatically
when the grill is turned on. It turns
off automatically when the grill or
griddle is turned off (0).
If blower speed is adjusted while
grilling, the blower will not turn
off automatically and must be
turned off manually.
The built-in vent system helps
remove cooking vapors, odors and
smoke from foods prepared on the
modules.
9