GE JXDD43, User Manual

Page: 6 / 36

General About
Components available are briefly
discussed on this page. You may
only have some installed in your
kitchen. All components are
permanently installed with the
exception of the grill and griddle.
Read each component section for
specific instructions.
Care of Components
Some of the components must be
cured or preconditioned before
using them for the first time.
Components and accessories
should be cleaned after each use.
The longer a soil remains, the
harder it is to clean. See each
component section in this manual
for specific instructions. Never
immerse any electric element or
in water.
Electric Element
Components
You must consider heat up and
cool down times for the elements
when determining cooking times.
Heat up and cool down times
depend on initial temperature
settings, the type of cookware
used and the amount of food
being cooked.
Start cooking at a higher setting to
heat the element faster, then turn to
a lower setting to finish cooking.
Remember, cooking continues
the element is turned off, so
train to turn the heat
down or off before cooking is done.
Gas Component
Monogram component gas
(used with either updraft
or downdraft venting) are designed
to operate on natural gas at 4“ water
column pressure.
Vent
The downdraft vent component
features an integral variable-speed
blower control switch and a
powerful centrifugal blower.
6
Components/Accessories
To purchase additional components or accessories, contact your nearest
GE Appliances dealer or service center. Part numbers are listed below.
Solid Disk Element
Part Numbers:
(208 volts) (240 volts)
Gas
Burner
Part Numbers:
Right Controls Left Controls
This component has one 6“ and
one 8“ solid disk element. The
elements are made of cast iron and
are sealed to the
Each
element has a built-in
automatic temperature
control.
This component has one large
1O,5OO-BTU burner (rear) and one
smaller 6,000-BTU burner (front).
The grate is removable for
cleaning.
Grate