14
Using the clock and timer.
To Set the Clock
The clock must be set to the correct time of day
for the automatic oven timing functions to work
properly. The time of day cannot be changed
during a timed baking or self-cleaning cycle.
Press the
CLOCK
pad.
Press the
INCREASE
or
DECREASE
pads.
Press the
START
pad.
Make sure the clock is set to the
correct time of day.
To Set the Timer
Press the
KITCHEN TIMER ON/OFF
pad.
Press the
INCREASE
or
DECREASE
pads
until the amount of time you want shows
in the display.
If you make a mistake press the
KITCHEN
TIMER ON/OFF
pad and begin again.
Press the
START
pad.
When the timer reaches
:00
, the control
will beep 3 times followed by one beep
every 6 seconds until the
KITCHEN TIMER
ON/OFF
pad is pressed.
The 6-second tone can be canceled by
following the steps in the S
pecial features of
your oven control
section under
Tones at the
End of a Timed Cycle
.
The timer is a minute timer only.
The timer does not control oven
operations. The maximum setting
on the timer is 9 hours and 59
minutes.
To Reset the Timer
If the display is still showing the time remaining,
you may change it by pressing the
KITCHEN
TIMER ON/OFF
pad, then press the
INCREASE
or
DECREASE
pads until the time you want
appears in the display.
If the remaining time is not in the display
(clock, delay start or cooking time are in the
display), recall the remaining time by pressing
the
KITCHEN TIMER ON/OFF
pad and then
pressing the
INCREASE
or
DECREASE
pads to
enter the new time you want.
To Cancel the Timer
Press the
KITCHEN TIMER ON/OFF
pad twice.
Power Outage
After a power outage, when power is restored
the display will flash and time shown will
QRORQJHUEHFRUUHFW³IRUH[DPSOHDIWHUD
5-minute power interruption the clock will be 5
minutes slow.
The display flashes until the clock is reset. All
other functions that were in operation when the
power went out will have to be programmed
again.
