Digital Clock and Minute Timer
The Electronic Digital Clocks on
your oven are accurate, solid-state
devices that serve several purposes.
As clocks, they display the time of
day on the display panel. When
functioning as a minute timer, they
count down the time you set to
and signal when they reach
the end of the time.
NOTE: Clock must be set on each
oven before electronic controls
will work in the oven.
To Set the Clock
When you first plug in
your
range, or after a power failure of
any kind, the digital displays show
for about 15 seconds, then
automatically change to “PF” (for
Power Failure). Your Electronic
Digital Clocks are now ready to
be set.
r
1
I I
II
3
MI N/SEC
TIMER
ON/OFF
8
Step 2: Touch the Number Pads for
Step 3: Touch the START pad.
This enters the time and starts the
clock. If you do not touch this pad,
the clock automatically starts after
6 seconds. If you have entered an
impossible time (such as
the
display flashes “EEEE” for Error.
If this should happen, just touch
the correct number pads and clock
starts. If “PF” appears, touch
CLOCK pad, then numbers to
start clock.
Correcting Time of Day: The time
of day cannot be changed during a
cooking operation. To change time
of day, touch CLOCK pad and
enter the corrected time.
Do not forget to set the clock in
the-minutes and seconds, just the
way you read them. During the
Minute Timing function, the
numbers to the left of the colon are
the minutes and the numbers to the
right of the colon are the seconds.
For example, to enter 10 minutes
and 45 seconds, touch Number
Pads 1,0,4 and 5 in that order. You
may program the timer for up to 99
minutes, 99 seconds. If you make a
mistake, touch MIN/SEC TIMER
pad and start again.
,’.., .
TIM
BAKE
TIME
the lower
as well as the upper
STOP
TIME
oven. If you don’t set the
the electronic controls in the
oven will not work.
Step 1: Touch the CLOCK pad.
The display shows
Step 3: Touch the MIN/SEC
TIMER pad. This starts the timer
immediately or after 6 seconds the
timer starts automatically. During
the timing function, the word
TIMER stays on and the time
counts down to
Note: A few seconds after
setting the clock in the lower
oven, the display will go blank
unless oven is being used. This
is normal. Touching any pad for
lower oven will reactivate display.
❑
CLOCK
❑
MIN/SEC
TIMER
ON/OFF
❑
3
❑
8
Step 4: When time is up, the
display shows
and a signal
sounds until you touch the MIN/SEC
TIMER pad. The display then
shows the time of day.
To Set the Minute/Second
Timer
Step 2: Touch the Number Pads
the same way that you read them.
As an example, to set
you
touch number pads 1, 2, 3 and 4 in
that order. If number pads are not
touched within several seconds
after CLOCK pad, “EEEE” flashes
and display reverts back to original
setting. If this happens, retouch
CLOCK pad and enter again.
Step 1: Touch the MIN/SEC TIMER
pad. The display shows
and
the word TIMER glows steadily.
7
