TONES AT THE END OF A TIMED CYCLE
At the end of a timed cycle, 3 short beeps will sound
followed by one beep every 6 seconds, until the
CLEAR/OFF pad is pressed. This continuous 6
second beep may be canceled.
To cancel the 6 second beep:
Press the BAKE and BROIL HI/LO pads
at the same time for 2 seconds until the
display shows "SF".
Press the KITCHEN TIMER ON/OFF
pad. The display shows "Con bEEP"
(continuous beep). Press the KITCHEN
TIMER ON/OFF pad again. The display
shows "bEEP." This cancels the one
beep every 6 seconds.
Press the START pad.
COOK AND HOLD
The cook and hold feature keeps cooked foods warm
for up to 3 hours after the cooking function is
finished. To activate this feature, follow the steps
below:
Press the BAKE and BROIL HI/LO pads
at the same time for 2 seconds until the
display shows "SF".
Press the COOKING TIME pad. The
display will show "HLd OFF." Press the
COOKING TIME pad again to activate
the feature. The display will show "HLd
On."
Press the START pad to activate the
cook and hold feature and leave the
control set in this special features
mode.
ERC III SPECIAL FEATURES
FAHRENHEIT OR CENTIGRADE TEMPERATURE
The ERC control is set to use the Fahrenheit
temperature selections, but you may change this to
use the Centigrade selections.
Press the BAKE and BROIL HI/LO pads
at the same time for 2 seconds until the
display shows "SF".
Press the BROIL HI/LO pad. The display
will show "F" (Fahrenheit). If this is your
choice, press START.
Press the BROIL HI/LO pad again. The
display will show "C" (Centigrade). If this
is your choice, press START.
CHANGING THE SPEED OF THE (+) OR (-) PADS
(ON SOME MODELS)
As you use the + or - pads when setting a time or
temperature, you may notice the display changes
slowly. This special feature allows you to change
the speed by performing the following steps:
Press the BAKE and BROIL HI/LO
pads at the same time for 2 seconds
until the display shows "SF".
Press the (+) pad. The display will
show you a set speed between 1 and
5.
Press the (+) pad to increase the
speed up to the number 5.
Press the (-) pad to decrease the
speed down to the number 1.
Press START to activate the setting
and leave the control set in this special
features mode.
– 15 –
HELPFUL USE AND CARE INFORMATION
CLOCK - The clock must be set before the control for the
oven will work. the time of day clock cannot be changed
during DELAY START. It can be changed during a
regular bake or broil operation.
KITCHEN TIMER - Does not control oven operation. You
may program the timer for activities up to 9 hours and 59
minutes. When the timer reaches " :00," the control will
beep 3 times followed by one beep every 6 seconds until
the KITCHEN TIMER ON/OFF pad is pressed. To cancel
the timer, press and hold the KITCHEN TIMER ON/OFF
until the word "TIMER" disappears from the display.
POWER FAILURE - If a flashing time is in the display,
you have experienced a power failure. Reset the clock.
PREHEAT NOTIFICATION TONE - When you set an
oven temperature the oven automatically starts to heat.
When the temperature inside the oven reaches your set
temperature a tone will sound to let you know to place
the food in the oven.
LIGHTING SURFACE BURNERS - When one burner is
turned to the LITE position, all the burners will spark.
The igniter switches now come as one assembly, each
one wired in parallel to the other.
BROILING - The oven door must be closed during
broiling operation.
SELF CLEANING - We recommend venting with an
open window or using a ventilation fan or hood during
the first self-clean cycle.
Do not use commercial oven cleaners or oven protectors
in or near the self-cleaning oven. A combination of any
of these products plus the high clean cycle temperatures
may damage the porcelain finish of the oven.
The oven front frame and the oven door outside the
gasket do not get cleaned by the self-clean cycle. On
these areas use detergent and hot water or a soap-filled
steel wool pad. Rinse well with a vinegar and water
solution. This will help prevent a brown residue from
forming when the oven is heated. Buff these areas with
a dry cloth. Do not clean the gasket.