GE IMRSEN-W12 Manual Download Page 1

Catalog Number: RSEN-W12

1

DESCRIPTION AND OPERATION

Line-voltage Wall Switch Occupancy Sensor

Total Lighting Control

Installation Instructions

IMRSEN-W12

FEATURES

The RSEN-W12 is a self-contained motion-sensing
lighting control which replaces a conventional wall
switch for energy savings and convenience. Lights turn
off automatically after a room is vacated.

Built-in sensors produce low intensity, inaudible sound and
detect changes in sound waves caused by motion, such as
walking into the room, reaching for a telephone, turning in a
chair. The sensor does not respond to audible sound.

In the Automatic ON mode, the lights turn on automatically
when a person enters the room. In the Manual ON mode,
lights are turned on by pressing the touchplate on the switch.
Modes can be changed by flipping the concealed switch under
the touchplate. In either mode, lights will remain on as long
as motion is detected in the room. When no motion is detected,
the lights will turn off automatically after the pre-set time
delay. Following this, a “grace period” of approximately ten
seconds allows lights to be turned on again by motion.

At any time, lights may be turned off while the room is
occupied by pressing the touchplate. The RSEN-W12 is fully
self-resetting; lights turned off manually in Automatic ON
mode will stay off while the room remains occupied. After the
room is vacated and the preset time delay and grace period
have elapsed, the lights will remain off until turned on
automatically the next time someone enters the room.

The RSEN-W12 can be used with a standard toggle switch to
split the lighting load for rooms that are wired for two
switches as shown in the wiring diagram.

• Replaces a conventional wall switch
• For use in small rooms or offices up to 300 square feet
• One model for either 120 VAC or 277 VAC
• Choice of automatic ON or manual ON modes
• Separate time delay and sensitivity adjustments
• For indoor use only

Before proceeding, read the enclosed installation
instructions. For GE TLC Service, call: 1-877-584-2685
(USA) or 1-800-661-619 (Canada).

Summary of Contents for IMRSEN-W12

Page 1: ...o motion is detected the lights will turn off automatically after the pre set time delay Following this a grace period of approximately ten seconds allows lights to be turned on again by motion At any time lights may be turned off while the room is occupied by pressing the touchplate The RSEN W12 is fully self resetting lights turned off manually in Automatic ON mode will stay off while the room r...

Page 2: ...20 VAC or 277 VAC only Do not use with any other voltage Do not wire to control receptacle circuits Verify that the connected load does not exceed the RSEN W12 ratings Use twist on wire connectors for all connections All installations should be in compliance with the NEC and all state and local electrical codes The RSEN W12 can be wired to control both an exhaust fan and lighting provided the tota...

Page 3: ...after the lights go out Walk normally back into the room and verify that the lights turn on automatically If not the Entry Range should be increased slightly Do not set higher than necessary 5 If the LED blinks when there is no movement in the room it is possible that the sensor is being activated by air flow from the HVAC system Reduce the Area Range setting until the LED goes off and stays off w...

Page 4: ...touchplate to verify the setting If set to Automatic ON mode the sensor may have been overridden by someone pressing the touchplate allow the RSEN W12 to time out to verify normal operation If the lights do not turn on after pressing the touchplate confirm that no other switches or equipment are interrupt ing or bypassing power to the sensor or the load If lights still do not turn on replace the R...

Reviews: