GE IDP-1111, User Manual, Page: 37 / 114

Chapter 5
Advanced programming
29
Coordinates page
You can display the dome’s pan, tilt, or zoom coordinates on the monitor screen, if desired. You can display
any or all of the coordinates. You can also choose how to display each one.
To access the Coordinates page, select Setup , Preferences , and Coordinates .
Figure 18. Coordinates page
Note: Remember to select OK to save any changes you make on the page.
Pan. The Pan feature displays the pan coordinate of the dome. Choices are Off, Bearings (compass
directions, such as N, NE, E), Degrees 360 (default), and Degrees ± 180.
Figure 19. Pan coordinates
Tilt. The Tilt feature displays the tilt coordinate of the dome. Choices are Off, Degrees 180 (default), and
D/- 90.
W / 270° / -90° E / 90° / +90°
N / 0° / 0°
Pan coordinates:
Bearings/Degrees 360 ° /Degrees ±180°
NE / 45° / +45° NW / 315° / -45°
S / 180° / +180°
SE / 135° / +135° SW / 225° / -135°
N / 0° / 0°
Units: Bearings/Degrees 360°/Degrees ±180°
NW / 315° / -45°
W / 270° / -90°
SW / 225° / -135°
S / 180° / +180°
NE / 45° / +45°
E / 90° / +90°
SE / 135° / +135°