8-58
Section 8-4 - System Modules- Replacement Procedures
D
IRECTION
5771498-100, R
EVISION
6
V
ENUE
™ S
ERVICE
M
ANUAL
P R E L I M I N A R Y
8-4-10-5
MPB Module Installation Procedure
1.) Insert the MPB module as follows:
a.) Insert the MPB module so that it goes under the Top Receptical Box. To do that, the MPB
Module must be inserted in angled position and not at 90°.
b.) Make sure all cable connectors are floating.
c.) Position the MPB Module at 90° and slide into the rails until the docking of the MPB module.
2.) Tighten the two mounting screws to secure the MPB module.
3.) Return the PSU module.
4.) Return the battery packs.
5.) Refit the following covers: MPB Door Cover, Lower Front eTower cover, Right Side and Left Side
eTower covers, and RS Probe cover
6.) Install all accessories.
7.) Turn ON power to the system.
•
PSU Module Installation Procedure
•
Battery Module Installation Procedure
•
MPB Door Cover Installation Procedure
•
Left Side eTower Cover Removal Procedure
•
Right Side eTower Cover Removal Procedure
•
Lower Front eTower Cover Removal Procedure
•
RS Probe Cover Installation Procedure
•
Summary of Contents for H45051VN
Page 477: ......