1
• Unstable installation may cause vibration
and noise.
• Wooden floor or carpet beneath the
refrigerator may be decolourized.
• Doors may not close properly if the
refrigerator is not leveled.
• Leave more than 6cm from 3 sides for
ventilation.
• Insufficient spacing may lead to
noise,vibration, lowering of refrigerating
perforormance and energy efficiency.
• Direct sun light, heat of stove or gas range
may decrease the refrigerating
performance.
• Avoid moisture and water for prevention of
rusting corrosion and electrical problems.
• Locate the refrigerator on concrete / cement
floor or solid board or plank.
1. Installation Instructions
Where the floor is solid and leveled
Where ventilation is good
Where there is little or no heat, moisture
Suitable Installation Place
Grounding is necessary
all the time
Grounding by using
grounding wire
Grounding by using
short-circuit breaker
Grounding is not necessary
You should not connect the
ground wire to
* The refrigerator is grounded if a 3-prong plug is used (depending on local electric code.)
■
Grounding terminal is the yellow/green one connected to the power cord in the back of refrigerator.
Bury copper plate to 25 cm deep in the ground with ground wire connected.
Short-circuit breaker is a must where the floor is always wet, for example, fish shop,
restaurant kitchen etc.
in case of using side-grounded outlet.
water pipe, gas pipe, telephone line,
lightening-rod.
There can be explosion or fire.
Grounding wire
Side
Grounded
outlet
Grounding
Correct usage of Refrigerator
Plug in the refrigerator right
after installation.
Set the fresh food compartment’
temperature to “7” to perform
preparatory run for 2 or 3 hours.
When the inside is cold enough,
put the foods in.
* See page
for details.
* When the surrounding temperature is hot in midsummer, do not open and shut the
doors too often after installation.
2
