GE Giraffe OmniBed, Service Manual

Page: 101 / 270

SOUTH
NORTH
(heater door end)
Inner south extrusion
Inner north extrusion
Corner pin
South seal
Side seal
Spacer
Set screw
Washer
Nut
Corner flange
North seal
Figure 5-2 Original Seal Parts
c. Using a 2.5 mm hex key or small Phillips screwdreiver, remove and discard the four screws that secure
the corner pins to the four corner flanges. Hold the corner pins in place while removing the screws.
Remove and discard the corner pins. Remove and discard the two south corner flanges. (Removal of
the north corner flanges is described in section 5.2.1.)
Nuts
Figure 5-3 Nuts
d. Using a 7 mm socket or wrench, remove and discard the four nuts and four star washers across the
north end of the heater door bracket that secure the canopy to the heater door bracket. (Two of the
nuts are accessed though the north access holes in the canopy bracket.) Take note where cable routing
clips are secured, for later reassembly.
© 2001 by Datex-Ohmeda, Inc.. All rights reserved.
6600-0343-000 104
73
Chapter 5: Repair Procedures