GE GEK-106273L, Instruction Manual

Page: 202 / 209

ANNEX 6 STATUS LIST
GEK-106273L MIF Digital Feeder Protection 16-3
NAME DESCRIPTION OPTION
0
OPTION
1
OPTION
2
settings group)
Events Number of events produced since the last time they
were deleted
Active table Shows which table is active (table 1 or table 2)
Frequency Frequency value entered in the “Frequency” setting
(general settings group)
Alarm Alarm contact status. This contact is enabled when
“Protection” is out of service, or when all trips are
disabled (either by setting or by digital input).
Output 1 Status of Auxiliary Output 1
Output 2 Status of Auxiliary Output 2
Output 3 Status of Auxiliary Output 3
Output 4 Status of Auxiliary Output 4
Input 1 Status of Digital Input 1
Input 2 Status of Digital Input 2
Ready Status of the READY LED. Same as for the alarm
contact.
Trip LED TRIP LED status
LED 1 LED 1 status
LED 2 LED 2 status
LED 3 LED 3 status
LED 4 LED 4 status
Logic 1 Output status of logic 1
Logic 2 Output status of logic 2
Logic 3 Output status of logic 3
Logic 4 Output status of logic 4
Table change Shows whether the Table 2 selection by digital input
is active. If so, Table 2 is shown; if not, the set table is
activated.
Settings change
disabled Shows whether the Settings Change is inhibited by
digital input. If so, it is not possible to change settings
or command operations from the PC or the MMI. The
table change is permitted by digital input.
Cold load pickup Shows whether the cold load pickup is activated.
Breaker 52a Status of the breaker terminal A.
Breaker 52b Status of the breaker terminal B
Breaker status Breaker status
Breaker failure Indicates a breaker failure
Counter Value of the I
2
counter
Number of openings Number of openings
I2 Alarm
Active when I
2
counter value exceeds the counter
maximum limit, set in the BREAKER FAILURE TO
OPEN group of settings.
Local/remote Active when the MMI is on the settings or operations