GE GE-DSH-73, User Manual

Page: 146 / 179

Chapter 6: Command Sets
142 GE-DSH-73/DSH-82 and DSH-82-PoE User Manual
Trunk Commands Set
Commands Level Description Example
aggregator priority
[1~65535]
G Set port group system
priority switch(config)#aggregator
priority 22
aggregator activityport
[Group ID]
[Port Numbers]
G Set activity port switch(config)#aggregator
activityport 2
aggregator group
[GroupID] [Port-list]
lacp
workp
[Workport]
G Assign a trunk group with
LACP active.
[GroupID] :1~3
[Port-list]:Member port list,
This parameter could be a
port range(ex.1-4) or a port
list separate by a
comma(ex.2, 3, 6)
[Workport]: The amount of
work ports, this value could
not be less than zero or be
large than the amount of
member ports.
switch(config)#aggregator
group 1 1-4 lacp workp 2
or
switch(config)#aggregator
group 2 1,4,3 lacp workp 3
aggregator group
[GroupID] [Port-list]
nolacp
G Assign a static trunk group.
[GroupID] :1~3
[Port-list]:Member port list,
This parameter could be a
port range(ex.1-4) or a port
list separate by a
comma(ex.2, 3, 6)
switch(config)#aggregator
group 1 2-4 nolacp
or
switch(config)#aggregator
group 1 3,1,2 nolacp
show aggregator P Show the information of
trunk group switch#show aggregator 1
or
switch#show aggregator 2
or
switch#show aggregator 3
no aggregator lacp
[GroupID]
G Disable the LACP function of
trunk group switch(config)#no aggreator
lacp 1
no aggregator group
[GroupID]
G Remove a trunk group switch(config)#no aggreator
group 2