GE F60 UR Series, Instruction Manual

Page: 50 / 558

3-2 F60 Feeder Protection System GE Multilin
3.1 DESCRIPTION 3 HARDWARE
3
Figure 3–2: F60 HORIZONTAL MOUNTING (ENHANCED PANEL)
Figure 3–3: F60 HORIZONTAL MOUNTING AND DIMENSIONS (STANDARD PANEL)
b) VERTICAL UNITS
The F60 Feeder Protection System is available as a reduced size (¾) vertical mount unit, with a removable faceplate. The
modular design allows the relay to be easily upgraded or repaired by a qualified service person. The faceplate is hinged to
allow easy access to the removable modules, and is itself removable to allow mounting on doors with limited rear depth.
There is also a removable dust cover that fits over the faceplate, which must be removed when attempting to access the
keypad or RS232 communications port.
The case dimensions are shown below, along with panel cutout details for panel mounting. When planning the location of
your panel cutout, ensure that provision is made for the faceplate to swing open without interference to or from adjacent
equipment.
The relay must be mounted such that the faceplate sits semi-flush with the panel or switchgear door, allowing the operator
access to the keypad and the RS232 communications port. The relay is secured to the panel with the use of four screws
supplied with the relay.
18.370”
[466,60 mm]
842808A1.CDR
0.280”
[7,11 mm]
Typ. x 4
4.000”
[101,60 mm]
17.750”
[450,85 mm]
CUT-OUT