GE F60 UR Series, Instruction Manual

Page: 378 / 558

6-24 F60 Feeder Protection System GE Multilin
6.4 RECORDS 6 ACTUAL VALUES
6
6.4RECORDS 6.4.1 FAULT REPORTS
PATH: ACTUAL VALUES
ÖØ
RECORDS
Ö
FAULT REPORTS
Ö
FAULT REPORT 1(15)
The latest 15 fault reports can be stored. The most recent fault location calculation (when applicable) is displayed in this
menu, along with the date and time stamp of the event which triggered the calculation. See the
SETTINGS
Ö
PRODUCT
SETUP
ÖØ
FAULT REPORTS
menu for assigning the source and trigger for fault calculations. Refer to the
COMMANDS
ÖØ
CLEAR RECORDS
menu for manual clearing of the fault reports and to the
SETTINGS
Ö
PRODUCT SETUP
ÖØ
CLEAR RELAY
RECORDS
menu for automated clearing of the fault reports.
6.4.2 EVENT RECORDS
PATH: ACTUAL VALUES
ÖØ
RECORDS
ÖØ
EVENT RECORDS
The event records menu shows the contextual data associated with up to the last 1024 events, listed in chronological order
from most recent to oldest. If all 1024 event records have been filled, the oldest record will be removed as a new record is
added. Each event record shows the event identifier/sequence number, cause, and date/time stamp associated with the
event trigger. Refer to the
COMMANDS
Ø
CLEAR RECORDS
menu for clearing event records.
NO FAULTS TO REPORT
or
„
FAULT REPORT 1
„
FAULT 1
LINE ID: SRC 1
Range: SRC 1, SRC 2
MESSAGE
FAULT 1 DATE:
2000/08/11
Range: YYYY/MM/DD
MESSAGE
FAULT 1 TIME:
00:00:00.000000
Range: HH:MM:SS.ssssss
MESSAGE
FAULT 1 TYPE:
ABG
Range: not available if the source VTs are in the “Delta”
configuration
MESSAGE
FAULT 1 LOCATION
00.0 km
Range: not available if the source VTs are in the “Delta”
configuration
MESSAGE
FAULT 1 RECLOSE
SHOT: 0
Range: where applicable
„
EVENT RECORDS
„
EVENT: XXXX
RESET OP(PUSHBUTTON)
↓
MESSAGE
EVENT: 3
POWER ON
EVENT 3
DATE: 2000/07/14
MESSAGE
EVENT: 2
POWER OFF
EVENT 3
TIME: 14:53:00.03405
MESSAGE
EVENT: 1
EVENTS CLEARED
Date and Time Stamps