CE marking
The CE marking and the corresponding EU Declaration of Conformity is valid for the in-
strument when it is:
•
used as a stand-alone unit, or
•
connected to other products recommended or described in the user documentation,
and
•
used in the same state as it was delivered from GE, except for alterations described
in the user documentation.
International standards
Notes
Description
Standard
EN standard is harmo-
nized with EU directive
2006/95/EC
Safety requirements for
electrical equipment for
measurement, control and
laboratory use
EN/ IEC 61010-1,
CAN/CSA-C22.2 No.
61010-1
EN standard is harmo-
nized with EU directive
2004/108/EC
Electrical equipment for
measurement, control and
laboratory use - EMC re-
quirements
EN/IEC 61326-1 (Emission
according to CISPR 11,
Group 1, class A)
EN ISO standard is harmo-
nized with EU directive
2006/42/EC
Safety of machinery. Gen-
eral principles for design.
Risk assessment and risk
reduction.
EN ISO 12100
FCC compliance
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
The user is cautioned that any changes or modifications not expressly approved
by GE could void the user’s authority to operate the equipment.
Note:
10
Ettan IPGphor 3 Operating Instructions 28-9635-51 AC
1 Introduction
1.3 Regulatory information
