GE DS-SD4-1, Reference Manual, Page: 16 / 76

6 SD Series Reference Manual (x710 Mode) MDS 05-4670A01, Rev. E
2.5 Accessories and Spares
Table 1 lists common accessories and spare items for the transceiver.
GE MDS also offers an
Accessories Selection Guide listing additional
items that can be used with the product. Contact your factory represen-
tative or visit
www.gemds.com
to obtain a copy of the guide.
3.0 APPLICATIONS
Point-to-Multipoint, Multiple Address Systems (MAS)
This is the most common application of the transceiver. It consists of a
central master station and several associated remote units as shown in
Figure 4. An MAS network provides communication between a central
host computer and remote terminal units (RTUs) or other data collection
devices. The operation of the radio system is transparent to the computer
equipment.
Often, such a system is used to convey telemetry data to and from
widely separated remote radios. Typical applications include automatic,
remote monitoring of gas wells, water tank levels, electric power distri-
bution systems, and similar control and measurement functions.
The radio system can replace a network of remote monitors currently
linked to a central location using leased telephone lines or other hard-
wired means. At the central office of such a system, there is usually a
dedicated computer and some means of switching between individual
Table 1. Accessories & Ancillary Items
Accessory Description Part Number
Retrofit Kit, Digital Contains adapters and connectors
needed to facilitate the replacement
of an existing MDS
x 710A/C/M
digital transceiver.
03-4696A01
Retrofit Kit, Analog Contains adapters and connectors
needed to facilitate the replacement
of an existing MDS
x 710A/C/M
analog transceiver.
03-4697A01
DC Power Plug,
2-pin, polarized Mates with power connector on radio
case. Screw terminals provided for
wires, threaded locking screws to
prevent accidental disconnect. 73-1194A53
Instruction Sheet
(for x710 Mode) Describes the installation and setup
of the transceiver. A companion to
this Reference Manual. 05-4669A01
Flat Mounting
Brackets
(Standard) Brackets that attach to the bottom of
the unit. Used for mounting to a flat
mounting service. 03-4123A14
DIN Rail Mounting
Bracket Kit Contains bracket for mounting the
transceiver to standard 35 mm DIN
rails commonly used in equipment
cabinets and panels.
03-4125A04