Control or Measure Parameter
© 2017 General Electric Company – All Rights Reserved.
ADTS 405 R/F Mk2 Instruction Manual-English | 29
Figure 4-3: Triple Display
4.1.2 Rate Timer Displays
When in Leak Measure mode and, after completing a rate timing, the system generates the
rate timer displays. These displays are independent of the display mode (single, dual, triple or
option).
Note:
There is no pointer for the primary parameter, values cannot be entered in the rate
timer displays.
Pressing a parameter key (
ALT
,
ROC
, etc) or
CLEAR/QUIT
exits the rate timer displays.
Figure 4-4: Rate Timer Display - Aeronautical Units
1
Constant indication of values.
2
Measured value.
3
“T” for timed rate of change.
4
Units of measurement.
5
Special messages, e.g. warm-up
period.
6
“<” Pointer for parameter, i.e. aim that
changes on data entry.
7
Aim (set-point or target) in control
mode, or “Leak Measure” when the
pressure controller is off.
8
Current changing parameter.
1
Measured parameter.
2
Measured value.
3
“T” for timed rate of change.
4
Units of measurement.
5
Special messages, e.g. warm-up
period.
Alt 1228 ft
CAS = 300.0 kts
ROC 2995 ft/m
Aim 3000< WARMUP
1
2
4
3
5
6
7
8
ROC -1.00T ft/m
RtCA -0.10T kts/m
Timed Rates WARMUP
2
4
3
5
1
