GE DMS Go+, Operating Manual

Page: 130 / 264

5 Operation Other functions
5-52 Edition 4 (05/2014) DMS Go+
– In the function group PROBE&CAL , select the func-
tion TEMP COMP .
– Press one of the left or right arrow keys in order to
choose the option ENABLE .
– Select the function CAL TEMP and set the tempera-
ture of the calibration block.
– Select the function CUR TEMP and set the tempera-
ture of the test object.
– Select the function TEMP COEF and set the tem-
perature coefficient.
– Finally, press the function key 1 (function HOME ) in
order to exit the function. The settings become effec-
tive immediately.
Note
The DMS Go+ can display both the uncom-
pensated and the compensated thickness
value at the same time. To achieve this, con-
figure the data boxes accordingly (see Sec-
tion
Configuring data boxes , page 5-13).
Display freeze (FREEZE)
You can freeze the display screen of the DMS Go+. The
A-scan and the displayed thickness value are then fro-
zen and no longer updated.
This function is available in all measurement modes and
display views.
When the function is active, a corresponding icon is dis-
played at the top left corner of the display screen (see
Section
Status display icons , page 0-5).
– In the function group MEASURE , select the function
FREEZE .
– Press one of the left or right arrow keys in order to
switch the function on.
Note
You can assign the function FREEZE to the
function key 4 (see Section Assignment of
function key 4 , page 5-7).