GE DINAMAP ProCare, Service Manual

Page: 51 / 134

Revision C DINAMAP
®
ProCare Monitor Service Manual 3-13
2009381-001
Installation: Host Communications Connector
Host Communications Connector
All host port signals are NON-ISOLATED and should be connected to equipment
conforming to IEC 601-1-1 ONLY. Where isolation of data communication is
required, the isolated level converter should be used. If external alarm control is
required, p/n 487208 (Isolated Remote Alarm Cable Assembly) should ALWAYS
be used. Please refer to the Information Sheet included with the isolated remote
alarm cable for operational details.
NOTE:
When using remote alarm, the ProCare Monitor should be considered
the primary alarm source. The secondary alarm is used for secondary
purposes only.
DB15 Connector Pin Assignments
Connection Details
Host Port Connector (rear panel)
WARNING! Auxiliary equipment connected to the DINAMAP
®
ProCare Monitor
will result in the formation of an electromedical system and thus, must comply
with the requirements of EN 60601-1-1/ IEC 601-1. All host port signals are NON-
ISOLATED and should be connected to equipment conforming to IEC-601-1,
configured to comply with IEC 601-1-1 ONLY. Where isolation of data
communication is required, GE Medical Systems
Information Technologies part
number ILC1926 should be used. If external alarm control is required, GE Medical
Systems
Information Technologies part number 487208 (Isolated Remote Alarm
Cable. When a high-priority alarm condition is displayed on the Monitor, the
remote alarm signal becomes active within 0.5 seconds. The active state of the
alarm signal is an open circuit. In the inactive state the alarm signal is connected
to ground. Please refer to the Information Sheet included with the isolated
remote alarm cable for operational details.
NOTE:
When using remote alarm, the ProCare Monitor should be considered
the primary alarm source. The secondary alarm is used for secondary
purposes only.