GE DigitalFlow GS868, Programming Manual

Page: 82 / 171

March 2008
3-4 Logging Data
STARTTIME Prompt (cont.)
a.
Press
[F1]-[F2]
to select
AM
or
PM
. Then, enter the desired Hour
(1-12) and press
[ENT]
. (Entry of a start time earlier than the
current time will generate an error message.)
b.
Enter the desired Minutes and press
[ENT]
. The acceptable
range is 0 to 59.
c.
Enter the desired Seconds and press
[ENT]
. The acceptable
range is 0 to 59.
START DATE Prompt
11.
Press
[F1]
to accept the displayed Start Date or press
[F2]
to enter a
different start date. To start logging today, press
[F3]
.
•
If
OK
or
TODAY
was selected, proceed to step 12 for a non-
circular log or to step 13 for a circular log.
•
Otherwise, complete the following steps to Edit the Start Date.
a.
Enter the desired Year and press
[ENT]
. The acceptable range is
0 to 99.
b.
Use the [
←]
, [
→]
and
[F1]-[F4]
keys to select the desired
Month .
c.
Enter the desired Day and press
[ENT]
. The acceptable range is
1 to the number of days in the selected month (28, 29, 30 or
31).
END TIME Prompt
12.
Press
[F1]
to accept the displayed End Time or press
[F2]
to enter a
different end time. To select a specific time period for the log to
run, press
[F3]
.
•
If
OK
was selected, proceed to the
END DATE
prompt.
•
If
TIMED
was selected, proceed to the
LOG TIME
prompt.
•
If
EDIT
was selected, complete the steps on the next page.
Note:
The log
END TIME
must exceed the log
START TIME
by at least
five minutes. Failure to observe this restriction will result in
an error message.
a.
Press
[F1]-[F2]
to select
AM
or
PM
. Then, enter the desired Hour
(1-12) and press
[ENT]
. (Entry of a start time earlier than the
current time will generate an error message.)
b.
Enter the desired Minutes and press
[ENT]
. The acceptable
range is 0 to 59.
c.
Enter the desired Seconds and press
[ENT]
. The acceptable
range is 0 to 59.