GE DigitalFlow GF868, Service Manual

Page: 46 / 74

Chapter 4. Parts Replacement
36 DigitalFlow™ GS868 Service Manual
4.5 Replacing the LCD Display
The Model GS868’s measurements are displayed on a a two-pane LCD graphic display panel. The LCD display
normally provides years of dependable service, but it is easily field-replaceable when necessary. To replace the LCD
display, see Figure 8 on page 39 for the component locations, and complete the following steps:
1. Remove the printed circuit board, as described in a previous section of this chapter.
2. Using a 3/16 in. nutdriver, remove the four nut/washer sets that secure the display shroud to the inside of the
console cover. Lift the display shroud off its mounting studs.
3. Using a 1/4” nutdriver, remove the four standoffs that secure the LCD display assembly to the console cover. Lift
the LCD display assembly off its mounting studs.
4. Place the new LCD display assembly over the mounting studs on the console cover and fasten it in place with the
four standoffs. Make sure that the LCD display assembly is oriented as shown in Figure 9 on page 40.
5. Position the LCD display cables between the two right side mounting studs, and install the display shroud over the
mounting studs. The top and bottom edges of the shroud are bent at a 90 ° angle to the main surface, and these edges
must face inwards toward the display assembly.
Note:
One edge of the display shroud is covered with a piece of black electrical tape. This side of the shroud should
be on the right, to protect the cables against abrasion.
6. Fasten the display shroud to the console cover with the four sets of nuts/washers.
To complete the LCD Display replacement, proceed to Installing the Printed Circuit Board on page 37.
CAUTION! Do not overtighten the standoffs or the display assembly may be damaged.
CAUTION! Do not overtighten the nuts or damage to the mounting threads may occur .