GE Dash D 0 0005 G Series, Service Manual

Page: 8 / 60

1-4 Dash Port Docking Station Revision B
2000966-037
Introduction: Safety Information
Safety Information
Responsibility of the Manufacturer
GE is responsible for the effects of safety, reliability, and performance
only if:
„ Assembly operations, extensions, readjustments, modifications, or
repairs are carried out by persons authorized by GE.
„
The electrical installation of the relevant room complies with the
requirements of the appropriate regulations.
„ The equipment is used in accordance with the instructions for use.
General
This device is not intended for home use.
Contact GE for information before connecting any devices to the
equipment that are not recommended in this manual.
Parts and accessories used must meet the requirements of the applicable
IEC 601 series safety standards, and/or the system configuration must
meet the requirements of the IEC 60601-1-1 medical electrical systems
standard.
Periodically, and whenever the integrity of the device is in doubt, test all
functions.
The use of ACCESSORY equipment not complying with the equivalent
safety requirements of this equipment may lead to a reduced level of
safety of the resulting system. Consideration relating to the choice shall
include:
„
use of the accessory in the PATIENT VICINITY; and
„ evidence that the safety certification of the ACCESSORY has been
performed in accordance to the appropriate IEC 60601-1 and/or IEC
60601-1-1 harmonized national standard.
If the installation of the equipment, in the USA, will use 240V rather
than 120V, the source must be a center-tapped, 240V, single-phase
circuit.