26
CRxFlex Operating Manual V1.11
Scanning an Image
The CRxFlex digitizer interface allows for the configuration and acquisition of
images from the CRxFlex digitizer hardware.
When active, the following interface will be available.
On connection to the digitizer, the scan button will be enabled.
To
start a scan proceed as follows’
1. Select RFID to get the below attribute values from the plate.
a. Scan Resolution
b. Erasure action
c. IP sensitivity
2. User also can set the attributes by unchecking RFID option
a. Adapt the scan resolution to 50 or 100 µm.
b. Select the erasure action (low
– medium – high
c. Enter the IP sensitivity code between (753 to 1343 , by default 1000.
Note: These settings will be used as of the next entered image plate.
3. IP Adapter setting can be selected as shown below.