GE CM6, Hardware Reference Manual

Page: 8 / 88

GE Intelligent Platforms – CM6 Hardware Reference Manual, Fourth Edition Page 7
against potential problems. Filtering, optical isolation, ESD gaskets and other
measures might be required at the physical point of entry (enclosure wall of box
or rack). For example it is state-of-the-art that protection can not be done at the
internal connector of an RTM if a cable is attached and routed outside the
enclosure. It has to be done at the physical entry point as specified above.
Products manufactured by GE Intelligent Platforms should normally be suitable
for use in properly designed and produced customer equipment (system boxes
or operational systems) without any major redesign. However, the systems
might be subject to problems and issues once assembled, cabled and used. The
end user, system integrator or installer must test for possible problems and in
some cases show compliance to local regulations as required in his country or
by the intended application.
Corporate addresses
Corporate headquarters
GE Intelligent Platforms, Inc.
2500 Austin Drive
Charlottesville, VA 22911
U.S.A.
Phone: +1-800-322-3616
Web: www.ge-ip.com
Regional headquarters
US Germany
Americas & Pacific Rim (Japan,
Korea, China, Philippines, AUS, NZ) Germany
GE Intelligent Platforms, Inc. GE Intelligent Platforms GmbH &
Co. KG
2500 Austin Drive Memminger Str. 14
Charlottesville, VA 22911 86159 Augsburg
U.S.A. Germany
Phone: +1-800-322-3616
Phone: +49-821-5034-0
Fax: +1- Fax: +49-821-5034-119
Web: www.ge-ip.com Email: sales.augsburg.ip@ge.com
GE Intelligent Platforms on the Web:
http://www.ge-ip.com
For contact and other information (service, warranty, support etc.) see address
list in chapter: ‘Support, Service’.