Hardware Installation
IST 008 Installing Frame Grabber Board
Page 55
n
IST 008
Installing Frame Grabber Board
Section 1: Introduction
This job card describes how to install the a frame grabber board into the Centricity RA600
Workstation.
Section 2: Tools Required
u
5 mm cross-head screwdriver
u
5 mm flat-head screwdriver
u
Grounding wristband
Section 3: Procedure
1.
Power off the system.
2.
Remove the left-hand half of the Dell 1400 computer case.
l
Slide the rear padlock hasp toward the chassis center and press the release button on the
lower front of the bezel and remove the left side of the case.
l
For detailed instructions, refer to the Dell Online Documentation, Dell PowerEdge System
Documentation, Dell PowerEdge 1400, PowerEdge 1400 Installation and Troubleshooting
Caution
!
The components inside the workstation computer case may be
damaged by static electricity. Observe standard grounding
precautions for handling static-sensitive components when
performing this procedure.
Summary of Contents for Centricity RA600
Page 16: ...Introduction Page 16 Illustration 1 2 Computer Unit Front View ...
Page 24: ...Introduction Page 24 Modality Type Description IP Address S M GW Port AE Title ...
Page 206: ...Software Procedures SW 006 Single Media Archive SMA Install Configure Test Page 206 ...
Page 274: ...Renewal Parts Page 274 Jorge Aguirre med ge com Maurice Robert med ge com ...