GE Cafe CGS980SEMSS, Owner'S Manual & Installation Instructions

Page: 15 / 60

C
o
n
su
m
e
r
S
u
p
p
o
rt
In
st
a
lla
tio
n
In
st
ru
c
tio
n
s
T
ro
u
b
le
sh
o
o
tin
g
T
ip
s
O
p
e
ra
tin
g
In
st
ru
c
tio
n
s
S
a
fe
ty
In
st
ru
c
tio
n
s
15
Not all features are on all models.
To Set the Clock
The clock must be set to the correct time of
day for the automatic oven timing functions
to work properly. The time of day cannot be
changed during a timed baking or self-
cleaning cycle.
Touch the CLOCK pad to set.
Touch the number pads.
Touch the number pads the same way you
read them. For example, to set 12:34, touch
the number pads
1, 2, 3 and 4 in that order.
If number pads are not touched within one
minute after you touch the
CLOCK pad, the
display reverts to the original setting. If this
happens, touch the
CLOCK pad and reenter
the time of day.
Touch the START pad until the time
of day shows in the display. This
enters the time and starts the clock.
To check the time of day when the display
is showing other information, simply touch
the CLOCK pad. The time of day shows until
another pad is touched.
To Set the Timer
The timer does not control oven operations.
The maximum setting on the timer is 9 hours
and 59 minutes.
Touch the KITCHEN TIMER ON/OFF pad.
Touch the number pads until the
amount of time you want shows in the
display. The maximum time that can be
entered in minutes is 59. Times more
than 59 minutes should be changed to
hours and minutes. For example, to
enter 90 minutes as 1 hour 30 minutes,
touch
1, 3 and 0 in that order.
If you make a mistake, press the KITCHEN
TIMER ON/OFF pad and begin again.
Touch the START pad. After pressing
the START pad, SET disappears; this tells
you the time is counting down, although
the display does not change until one
minute has passed.
When the timer reaches :00, the control
will beep 3 times followed by one beep
every 6 seconds until the
KITCHEN
TIMER ON/OFF pad is touched.
The 6 second tone can be canceled by
following the steps in the Special features
of your oven control section under Tones
at the End of a Timed Cycle.
Using the clock and timer.
GEAppliances.com
Make sure the clock is set to the correct
time of day.
The timer is a minute timer only.
The CLEAR/OFF pad does not affect
the timer.