GE ArcamEBM Spectra H, Operation Manual, Page: 100 / 142

7
Software
Overview
7 7..1 1..3 3..1 1 L Le efftt P Pa an ne ell
The buttons on the fixed left panel runs what is shown in the main window.
Depending on user type, different buttons are shown.
S Stta arrtt
Start or resume the melting process.
Possible reasons why the start button is not enabled:
• One or several of the status indicators are not green.
• Themes have not been selected.
• There are unacknowledged errors or fatal alarms on the alarms page.
• The rake is moving.
• A simulation is running.
• The beam has not been calibrated.
• The manual control is running.
S Stto op p
Immediate stop an ongoing melting process. An ongoing table or rake movement
will first be completed. Even the shortest stop/pause in the build process can fail a
restart of the actual build.
P Pa au usse e
Stop the melting process after processing of the current layer. This button is visible
only for users with administrator access.
O Ovve errvviie ew w
Display the build information in the overview window.
M Me en nu u
Divided into four sections: Setup, Controls, Settings, and System.
96 02 OM-710430 en-GB