GE AquaTrans AT868, User Manual, Page: 29 / 158

September 2004
2-4 Programming Site Data
Selecting Mass Flow Units
1.
Press [
W
]
and [
X
] to select the desired mass flow units for the
flow rate display and press
[ENTER]
. The available units for this
prompt are determined by the selection made at
SYSTEM UNITS
.
2.
Press [
W
]
and [
X
] to select the desired time units for the mass
flow rate display and press
[ENTER]
.
3.
Press [
W
]
and [
X
] to select the desired number of digits to the
right of the decimal point in the mass flow rate display and press
[ENTER]
.
4.
Press [
W
]
and [
X
] to select the desired units for the totalized mass
flow rate display and press
[ENTER]
. The available units for this
prompt are determined by the selection made at
SYSTEM UNITS
.
5.
Press [
W
]
and [
X
] to select the desired number of digits to the
right of the decimal point in the totalized mass flow rate display
and press
[ENTER]
.
Procedure Options
After completing the above steps, the user program returns to the
Channel PROGRAM
window. Do one of the following:
•
To continue entering “quick startup” data, press
[ESC]
once and
proceed to Step 3 in the following section.
•
To continue regular programming, refer to Appendix A, Menu
Maps , to navigate to the desired menu.
•
To leave the user program, press
[ESC]
three times.