For Normal Cooling
1. Set Selector Switch HIGH
COOL.
Set Thermostat Control at
desired number (usually the midpoint
is a good starting position). If room
temperature is not satisfactory after
a reasonable time, set the temperature
control at a higher number for a
cooler room or at a lower number
for a warmer room.
For Maximum Cooling
1. Set Selector Switch at HIGH
COOL.
2. Set Thermostat Control at 10.
3. Set Ventilation Control at
CLOSE position.
4. Shift Energy Saver Switch to
NORMAL.
For Quieter Operation
1. Set Selector Switch at LOW
COOL.
2. Set Thermostat Control at
number.
3. Set Ventilation Control at
CLOSE position.
4. Shift Energy Saver Switch to
desired position–NORMAL or
SAVE.
For Nighttime Operation
During the cooler evening hours,
it is recommended that you set the
Selector Switch at LOW COOL
for very quiet operation and the
Thermostat Control at mid-range
(5 or 6).
When the Thermostat Control is
set on 9 or 10 and the Fan is set on
low speed, moisture may freeze on
the coils and prevent the unit from
cooling. If this happens, set the Fan
at high
and set the Thermostat
Control to a lower number.
For Extreme Temperatures
For greatest economy and best
performance, we suggest you
always set the Selector Switch at
HIGH COOL in extremely hot
weather.
For air circulation and
filtering without cooling
or heating
Set Selector Switch at FAN ONLY.
For fan only operation, the Energy
Saver Switch must be in the
NORMAL position.
For Ventilation
Whether controls are set for cooling,
heating or fan only operation, setting
Ventilation Control at OPEN lets
room air be exhausted to the
outside. This is helpful in removing
stale air, smoke or odors from the
room, and permits outdoor air to
enter through normal openings in the
house. However, cooling effectiveness
is reduced when this control is set
OPEN, so we suggest you don’t
keep it there long—especially in
hot, humid weather.
For Normal Heating
1. Set Selector Switch at HIGH
HEAT.
2. Set Thermostat Control at
desired number (usually the midpoint
is a good starting position). If room
temperature is not satisfactory after
a reasonable time, set the temperature
control at a lower number for a
warmer room or at a higher number
for a cooler room.
For Maximum Heating
1. Set Selector Switch at HIGH
HEAT.
2. Set Thermostat Control at 1.
3. Set Ventilation Control at
CLOSE position.
4. Shift Energy Saver Switch to
NORMAL.
To Adjust Air Direction
Up-and-down air direction: Tabs
(A) let you direct discharged air up,
down or straight ahead.
Side-to-side air direction: Tab (B)
lets you direct discharged air to the
left, to the right or straight ahead.
5
