GE AKTAprocess, Operating Instructions Manual

Page: 147 / 180

WARNING
For continued protection against injury risks due to fluid jets, burst
pipes or potentially explosive atmosphere, the piping system must
be tested for leakage at maximum pressure:
•
After assembly or maintenance
• Before operation or CIP
User-allowed actions
The following components may be disassembled or assembled by the user:
•
The filter cartridge (optional)
•
TC-connection gaskets, in cases where the TC-connection can be dismantled without
the need to remove any components from the system.
•
The operator panel. This might be required for protection or space reasons if the
system shall be moved.
• The pH probe, see Section 6.5 Calibration of pH probe, on page 148 and Section 6.6
Repair and calibration, on page 151.
Other components
Other than described in this chapter, ÄKTAprocess is not designed to be disassembled
or assembled by the user.
If the need for further disassembly should arise, always contact your GE Healthcare
representative for advice before attempting any actions not described in this document.
ÄKTAprocess Operating Instructions 29-0252-49 AA 147
6 Maintenance
6.4 Disassembly and assembly