GE 5448623, Basic Service Manual

Page: 58 / 289

Site Preparations
2-6 Venue 50 – Basic Service Manual
5447566-100 English Rev. 7
Electrical requirements
General requirements
NOTE: GE requires a dedicated power and ground for the proper
operation of its Ultrasound equipment. This dedicated power
shall originate at the last distribution panel before the Ultrasound
system.
Sites with a mains power system with defined Neutral and Live :
The dedicated line shall consist of one phase, a neutral (not
shared with any other circuit), and a full size ground wire from
the distribution panel to the Ultrasound outlet
.
Sites with a mains power system without a defined Neutral :
The dedicated line shall consist of one phase (two lines), not
shared with any other circuit, and a full size ground wire from the
distribution panel to the Ultrasound outlet
.
NOTE: Please note that image artifacts can occur, if at any time within
the facility, the ground from the main facility's incoming power
source to the Ultrasound system is only a conduit.
Electrical requirements for the Ultrasound system
Inrush Current
Inrush current is not a factor to consider due to the inrush
current limiting properties of the power supplies.
Table 2-3: Electrical Specifications for Venue 50 system
Voltage Power Current Frequency
100-240 VAC 180 VA max. 1.6A (max) 50/60HZ
Table 2-4: Electrical Specifications for Docking Cart
Voltage Power Current Frequency
100-240 VAC 380 VA max. 2.7A (max) 50/60HZ
Table 2-5: Inrush Current
Voltage Inrush Current
100V 75A (max)
240V 120A (max)