9
About cycle options.
NOTE:
Not all features are available on all dryer models .
GEAppliances.com
Extended Tumble
Minimizes wrinkles by adding approximately
60 minutes of no-heat tumbling after clothes
are dry . The beeper will sound every two
minutes as a reminder to remove the clothes .
The
ESTIMATED TIME REMAINING
display will
show
00
.
The Extended Tumble time does not get
added to the cycle time on the display
Damp Alert
This option causes the dryer to beep when
clothes have dried to a damp level . Remove
items that you wish to hang dry . The
DAMP ALERT
will only beep when this option
is selected .
Removing clothes and hanging them when
they are damp can reduce the need to iron
some items .
Delay Start
Use to delay the start of your dryer .
1 . Choose your dry cycle and any options .
2 . Press
DELAY START
. You can increase
the delay time in 1 hour increments using
the
DELAY START
button .
3 . Press the
START
pad to start
the countdown .
NOTES:
n
If the door is opened while the dryer is
in
DELAY START
, the countdown time
will not restart unless the door is closed
and
START
has been pressed again .
e-DRY
Reduces the total energy consumption of
specific dryer cycles by adjusting certain
heat settings .
Note:
Cycle times will change when
e-DRY
is
selected.
This feature can be used with
DELICATES,
ACTIVE WEAR, EASY CARE, NORMAL/MIXED
LOADS
and
COTTONS.
Signal
Alerts you that the cycle is complete .
The beeper will continue to sound every
minute for the next 5 minutes, until the
clothes have been removed . The clothes
should be removed when the beeper goes
off so wrinkles don’t set in .
Press
SIGNAL
to select low, medium or high
volume, or to turn the beeper off .
