1
Digital Converter Box requires a short amount of
time to turn-on.
-
Verify the Digital Converter Box is plugged
into AC power.
-
Make sure remote has fresh batteries.
Does not receive specific channel anymore
-
Use the signal indicator to optimize placement
of the antenna
-
A better antenna may be required.
-
Some channels may not have sufficient
signal in your area.
Digital Converter Box shuts off automatically
-
For energy savings the Digital Converter Box is
shipped with sleep mode enabled at four hours
as required by the governing agency. To adjust the
setting or turn sleep mode off go to pg 14.
Error message reads no TV channels
-
Make sure you have an antenna connected
to the Digital Converter Box.
-
Adjust your antenna and re-scan for channels.
-
Try a different/better antenna and re-scan
for channels.
It takes several seconds for a picture to
appear when I change channels
-
This is normal.
-
Digital signals have to be decoded unlike the old
analog signals.
If you press a command on the remote and
the converter performs a previous command
-
The Digital Converter Box didn’t see the full
command. Release the button, make sure the
remote is pointed at the Digital Converter Box.
Re-press the command again. You may need to
reposition the Converter Box to be facing you.
Additional assistance can
be found at www.jascoproducts.com
Trouble
Shooting
Summary of Contents for 22730
Page 47: ...47...
