35
Upgrading firmware
Digia is designed to be upgradable through firmware updates. To
upgrade the firmware, the Digia must be in engineering mode.
To start engineering mode, do the following:
1. Press the
Setup
button and enter the admin password
(default is
1111
).
2. Go to the
System
menu and select the
Admin password
menu item.
3. Enter the password as
12341234
, and press the
SEL
button.
Note:
To exit engineering mode, regardless if you’ve upgraded or not,
select Boot Application.
When in engineering mode (
on page 36), you can
select the method to use when upgrading. The two methods
available are a
USB Upgrade
and
Network Upgrade
.
Note:
There are menu items described as test modes. These tests are
used for manufacturing purposes only.
CAUTION:
Upgrade procedures may change between releases of
firmware updates. Refer to the release notes included
with each firmware update before proceeding with the
upgrade process.