GE Multilin C60, Instruction Manual

Page: 369 / 544

GE Multilin C60 Breaker Protection System 7-5
7 COMMANDS AND TARGETS 7.2 TARGETS
7
b) MAJOR SELF-TEST ERROR MESSAGES
The major self-test errors are listed and described below.
• Latched target message : Yes.
• Description of problem : Module hardware failure detected.
• How often the test is performed : Module dependent.
• What to do : Contact the factory and supply the failure code noted in the display. The “xxx” text identifies the failed mod-
ule (for example, F8L).
• Latched target message : Yes.
• Description of problem : One or more installed hardware modules is not compatible with the C60 order code.
• How often the test is performed : Module dependent.
• What to do : Contact the factory and supply the failure code noted in the display. The “xxx” text identifies the failed mod-
ule (for example, F8L).
• Latched target message : No.
• Description of problem : The configuration of modules does not match the order code stored in the C60.
• How often the test is performed : On power up. Afterwards, the backplane is checked for missing cards every five sec-
onds.
• What to do : Check all modules against the order code, ensure they are inserted properly, and cycle control power. If
the problem persists, contact the factory.
• Latched target message : No.
• Description of problem : A FlexLogic™ equation is incorrect.
• How often the test is performed : The test is event driven, performed whenever FlexLogic™ equations are modified
.
• What to do : Finish all equation editing and use self tests to debug any errors.
• Latched target message : No.
• Description of problem : The
PRODUCT SETUP
ÖØ
INSTALLATION
Ö
RELAY SETTINGS
setting indicates the C60 is not pro-
grammed.
• How often the test is performed : On power up and whenever the
PRODUCT SETUP
ÖØ
INSTALLATION
Ö
RELAY SETTINGS
setting is altered
.
• What to do : Program all settings and then set
PRODUCT SETUP
ÖØ
INSTALLATION
Ö
RELAY SETTINGS
to “Programmed”.
MODULE FAILURE___:
Contact Factory (xxx)
INCOMPATIBLE H/W:
Contact Factory (xxx)
EQUIPMENT MISMATCH:
with 2nd line detail
FLEXLOGIC ERROR:
with 2nd line detail
UNIT NOT PROGRAMMED:
Check Settings