GE Medical Systems Dash 3000, Service Manual, Page: 46 / 232

INSTALLATION: Connections
3-4 Dash 3000/4000 Patient Monitor Revision B
2000966-105
Remote Control The remote control connects to the monitor via a communications cable
which plugs into an Autoport to Mport adapter before it is inserted into
the Aux port on the Dash monitor or the Dash Port docking station.
The remote control is programmed for specific care areas (adult,
neonatal, or operating room).
NOTE
The error message WARNING: REMOTE
MISMATCHED WITH MONITORING MODE displays if
a mismatched remote control is connected to the monitor.
Defib Sync The connector provides ECG analog output signals to user-supplied
equipment.
CAUTION
Equipment damage. Connect all peripheral equipment
before plugging the power cord into an AC outlet.
Otherwise, connectors may be damaged.
AC Power Use this connector to apply power to the monitor. The monitor will be
powered at all times when using AC power (there is no AC power switch).
The monitor is preset at the factory for a specific line voltage. Before
applying power, verify the monitor’s line voltage setting matches your
power supply. If required, use a small bladed screw driver to change the
line voltage setting. Refer to the label on the back of the unit for the
voltage and current requirements.
822A
remote control
adapter
Aux port
115V
line voltage selector
115V for a 100-120V power source
230V for a 220-240V power source