GE HEALTHCARE E-PSMP, Technical Manual

Page: 270 / 622

Module Frames and Modules
8 - 20
2062973-004
•
Check that the tubing inside the module is not contaminated. Any contamination
inside the tubing may indicate that the valves or sensors are contaminated, too. This
can increase a risk of faulty operation in valves or sensors. The valves or gas sensors
are not possible to clean in the field. Therefore, if you noticed any contamination in
the module tubing, send the module to GE for factory service.
NOTE: The nafion tubes do not include the silicon fittings they connect to. Use the original
silicon fittings unless they are damaged or leaking.
3.
Replace the OM reference gas filter assembly.
4. Check that the fan and ventilation hole are not covered in dust.
3.2 Visual inspections
Detach the module from the module slot and check that:
•
the front cover is intact
•
all connectors are intact and are attached properly
•
the module box and latch are intact
•
the D-fend Pro and its connectors are clean and intact
•
the module and the applied parts are clean
The cleaning precautions, cleaning requirements, cleaning procedures, and recommended
cleaning solutions for the monitor are described in the CARESCAPE monitor user’s manual. For
details about cleaning, disinfecting and sterilizing the accessories, see the instructions for use
in the accessory package.
3QHXPDWLFVEORFN
=HURYDOYH
73;PRGXOH
20PRGXOH
&2
DEVRUEHU
3XPS
'IHQG3UR
7R20 5HIHUHQFHJDVFRQQHFWRU
ORFDWHGRQWKHVLGHRIWKH
PRGXOHXQGHUWKHIURQWFRYHU
7RVDPSOHJDVRXW
JDVH[KRXVW
FRQQHFWRUDW
)URQW&RYHU
1DILRQWXEH
]HUROLQH
1DILRQWXEH
PDLQIORZ
73;
20RXW
20UHI
6)
)/
)/
3XPS 20UHI