GE HEALTHCARE CARESCAPE Monitor B650, Technical Manual

Page: 77 / 240

Configuration
69
2062973-002
7 Configuration
The configuration of the patient monitor consists of platform configuration and clinical
configuration.
This chapter describes how to perform the platform configuration tasks needed to take the
patient monitor into use for the first time and the configuration tasks needed for administration
and maintenance thereafter.
For information on how to perform the clinical configuration, including care unit settings and
user profiles, refer to the patient monitor’s user’s manual.
7.1 Adjusting display
7.1.1 Adjusting the brightness of the integrated primary display
If needed, adjust the display brightness from the Monitor Setup > Brightness menu. Refer to
the patient monitor’s user’s manual for more information.
7.1.2 Calibrating a touchscreen
NOTE: The touchscreen function of the integrated primary screen has been calibrated in the
factory. Re-calibration is typically needed only after replacing the uDOM or the touchscreen
sensor.
Calibrate the connected touchscreens, one by one, as follows:
1.
Select Monitor Setup > Service Calibrations.
2. In the Enter Password dialog box, type the username and password and press
Enter
.
Username: biomed
Password: Change <space> Me
NOTE: Username and password are case sensitive.
NOTE: The factory default password for the username “biomed” is
“
Change Me”.
3. In the Service / Calibrations menu, select Touch Screen to calibrate the integrated
primary display or the connected secondary display.
4. The Touch calibration screen opens.
5. Touch the calibration mark or cross hair (+) in each corner of the screen, according to the
instructions shown on the screen.
7.1.3 Adjusting optional secondary display
If needed, adjust the picture on the display using the Auto Adjustment feature in the display’s
OSD menu. Refer to the display's user manual for details.
7.2 Configuring the network
7.2.1 Configuring hostname
1. Log in to Webmin
2. Select Configuration > Network > Hostname.
The Hostname Configuration window opens.
The current hostname is shown in the Current Value column.