GE HEALTHCARE B20, User'S Reference Manual

Page: 241 / 320

Non-invasive blood pressure
14-7
Starting
Note that the measurement unit may be mmHg or kPa. The unit is selected during
configuration through
Monitor Setup
- Install/Service - Installation - Units .
You can start the NIBP measurement using either the direct function keys, or from the NIBP
menu by pressing the
NIBP
key.
In the beginning of the measurement, sys and dia labels are replaced by the inflation limit
indication (
Adult/Pediatric, Neonatal ) for five seconds. The cuff pressure is displayed in the
mean pressure value field.
If motion artifacts are detected, the monitor automatically holds deflation until the motion
stops (maximum of 30 seconds). If the artifacts prevent proper measurement, a new
measurement starts automatically.
When the measurement is ready, you can hear a short beep and see the result numbers
flashing.
During measurement
•
Observe the cuffed limb frequently. Measurement may impair blood circulation. Intervals
below 10 minutes and STAT measurements are not recommended for extended periods
of time.
•
Make sure that the tubes are not bent, pressed or stretched. Measurement may be
impaired.
•
Blood pressure values may be affected by a change in the patient's position.
•
The presence of some arrhythmias during NIBP measurement may increase the time
required for the measurement.
NIBP