GBC StreamWire, Service Manual

Page: 136 / 455

GBC StreamWire 7/23/2020 Repairs/Adjustments
4-39
REP 2.26 Upper Transport Latch Replacement
PARTS LIST ON PL 5.4
Use this procedure to remove and install the latch on the Upper Bypass
Assembly.
Removal Procedure
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Do REP 1.1
Top Cover Replacement to remove the Top Cover.
4. While supporting the upper transport with your free hand, release
the latch by pressing down on the pivot arm. Raise the Upper
Bypass carefully, it will rise quickly without the weight of the cover.
5. Remove the old Latch Assembly by removing the M4 Screws (4)
Installation Procedure
1. Place the new Latch onto the Upper Transport surface and secure it
using the M4 Screws (4).
2. Lower the Upper Bypass and gently seat the Upper Bypass by
pressing down on the Upper Bypass. If horizontal adjustment of the
Interlock Bracket is required, do REP 1.8 Front Cover Replacement
to remove the Front Cover.
3. Close the latch by lowering the Upper Bypass Assembly fully.
Ensure that the latch engages properly with the Catch. If necessary,
adjust the vertical position of the Catch by loosening the Screws on
the Catch Bracket and adjusting the position. A properly seated
cover will have around 1mm of movement.
4. Do REP 1.1 Top Cover Replacement to install the Top Cover.
5. Connect the Power Cord.
6. Power ON the eWire.