© GBC Pro - Tech August 1999
Page 6 - 78
F - 160 Operation and Maintenance Manual
Applications
Caution should always be exercised
when using the laminator with
the safety shields raised.
You can be seriously HURT or INJURED!
W A R N I N G
e) Raise the pull roller up by turning the crank
handle counter clockwise until the pull rollers
are separated.
f) Remove the front infeed table.
g) Cut the web of thermal laminate and mount
adhesive at the upper and lower unwind shafts
with an enclosed blade.
CAUTION
Do not use an open blade to cut
the web near the rollers.
You can put cuts into the rollers!
h) Remove the web from the front of the laminator
and the rolls of material from the upper and
lower unwind shafts.
This will prevent any exposed adhesive from
contacting the rollers.
INFORMATION
i) Clean the rollers as described in the
maintenance section. ( Section 8.2 Cleaning
the rollers )
If the rollers have no adhesive on them,
proceed to the second pass of this
application.
INFORMATION
Pass two : Mount
Use Chart 10 and Diagram 10 for assistance.
W A R N I N G
Do not wear ties, loose fitting clothing or
dangling jewelry while operating or
servicing the laminator. These items can get
caught in the nip and choke you or you can
be crushed or burned.
