6
GB
AdvancedPunch
TM
Pro
4. USER OPERATIONS
A.
Interchanging Die Sets:
Are completed without tools and only take seconds to perform
B.
Punch Chip Container:
Easy-to-access chip tray for quick chip disposal
C.
Die Set Storage:
Holds up to 2 spare Die Sets
D.
Punch Bypass:
Short straight-through paper path for unpunched documents
E.
Punch Mode Path:
Wide radius turn can support stocks up to 300g/m
2
cover
Paper flow and User Interactive sections of AdvancedPunch Pro
A.
Interchanging Die Sets:
Your AdvancedPunch Pro offers the convenience of interchangeable
die sets, allowing you to economically punch documents for a wide
variety of binding styles. Changing the machine's die sets is both quick
and easy, as the following instructions illustrate:
Note: For advanced Die Set Configuration instructions- See Section 8
Die Set User Manual.
Removing Die Sets from the Machine:
The inter-changeable die set
slot of the AdvancedPunch Pro is located adjacent to the Punch Chip
container at the bottom of the punch.
Step 1:
Stop the printer/copier.
Step 2:
Open the AdvancedPunch Pro access door panel.
Step 3:
Securely grasp the die lock handle and rotate it in the
CCW direction, as indicated in the label near the die lock handle.
This releases the die from the locked position.
Step 4:
Slide the die set out until it is fully removed, supporting it
with both hands.
Step 5:
Properly store the removed Die Set in the Die Set storage
area. (keep away from dust, dirt, accidental falls from the edge of
counters, etc.).
Step 6:
Select the desired Die Set for your new job and slide it into
the Die Set slot. Push the Die set firmly until the Die stop feature
contacts the round magnet. This is critical in ensuring the proper
position of the die set.
Step 7:
Grasp the handle and rotate it in CW direction until the
latch is fully engaged, as shown indicated in the label.
WARNING: POSSIBLE PINCH POINT HAZARD. WHEN
INSTALLING DIE SETS IN YOUR ADVANCEDPUNCH PRO,
ALWAYS KEEP FINGERS AND OTHER BODY PARTS OUT
OF THE MACHINE’S DIE SET SLOT AND AWAY FROM ALL
AREAS OF THE DIE SET, EXCEPT FOR THE FINGER HOLE
IN THE DIE SET. FAILURE TO FOLLOW THESE
PRECAUTIONS MAY RESULT IN INJURY.
Step 8:
Close the Access Door Panel.
Step 9:
Proceed with your printing and punching job.
Please note that when using a new die some oil will be present around
the punched holes on the sheet. After punching 25 to 50 sheets the die
will no longer leave oil on the sheets. It is recommended that a short
test print job be run after installing a new die or a die that has recently
been oiled.
B.
Punch Chip Container:
The Punch Chip Container for your AdvancedPunch Pro is located at
t
he front of the machine’s base. The drawer should periodically be
pulled out and emptied. The AdvancedPunch Pro uses a sensor to
determine when the punch container is full. Once the punch container
becomes full the LCD display shows "Chip Tray Full" message and a
message also appear on the printers user interface screen.
When the
“Chip Tray Full” message is displayed, Slide the Punch Chip Container
out until it is fully removed, supporting it with both hands. After
emptying, reinsert the container- this will clear the Chip Tray Full
message.
