Gazelle Easyflow HMS, User Manual

Page: 105 / 480

Gazelle Easyflow HMS Manual | 37
Using the bike
3.8.3 Walk Assist
The Walk Assist function can make it easier to push the bicycle
while walking. The speed in this function depends on the
selected gear and can reach up to 6 km/hour. This function
must only be used when wheeling the bicycle on foot.
Before using the Walk Assist take the following into
consideration:
•
This function must only be used when wheeling the bicycle
on foot.
•
When the Walk Assist has been switched on it is possible
that the pedals will also move. When Walk Assist has been
activated take care that your legs are far enough away from
the moving pedals. There is the risk of injury.
Switching on Walk Assist:
1. Press the button

46
until the Walk Assist symbol
appears on the display.
2. Push the bike forwards whilst pressing button

46
at the
same time.
The drive of the bicycle switches on.
The Walk Assist remains active as long as you
keep button

46
pressed.
"
WARNING
" There is a risk of injury if the wheels of
the bicycle are not in contact with the ground
when using Walk Assist.
"
WARNING
" Before using Walk Assist ensure that
you have read and understood the below
instructions.
43
46
49
"
REMARK
" If nothing happens for a minute after
switching it on, the Walk Assist stops
automatically.
"
REMARK
" The Walk Assist function cannot be
activated at assistance level
OFF
.