OR
OR
2009-13, Ford F-150
Front Upper Mount Kit
5/8” Offset
Mounting Instructions
Part #756683
IMPORTANT:
Manufacturer is not responsible for negligent use of vehicle with mud flaps installed, or
over-tightening of screws and bolts causing damage to vehicle or mud flaps
.
TOOLS REQUIRED
Electric or Re-Chargeable
3/8” Socket ¼” Drill Bit Robertson
Phillips
5/16” & 3/8” Open
7/32” Open End
½” or 3/8” Drill
Driver
Screwdriver Screwdriver End or Socket Wrench
or Socket Wrench
KIT CONTENTS:
a) (1)Upper Mount
b) (1) Upper Mount
c) (2) Rear Strip
d) (4) Screw, SS
Driver’s Side
Passenger Side
1” x 12”, SS
#10 x 1.25”
Part #755539
Part #755540
Part #755523
Part #010017
e) (8)Screw, Machine
f) (6) Tek Screw
g) (6) Washer, Flat,
h) (2) Washer, Half
8-32 x ½”, SS
¼ x 14 x 1.25”
0.203”x1.00”, SS
0.281”x1.000”, SS
Part # 012031
Part #010011
Part #018031
Part #018029
i) (2) Washer, lock
j) (2) Nut, Hex
k) (4) Washer, Flat
l) (2) Washer, Half
#10, Helicoil, SS
#10 – 24, SS
0.281”x1.0”, SS
0.203 x 1.0”, SS
Part #024001
Part #025003
Part #018028
Part #018032
Before you install your Mud Flap, see the above diagrams and parts list for all necessary parts.
Start on the driver’s side
.
INSTALLATION
For ease of installation, it is suggested that the wheel be removed.
1.
Before you install your Mud Flaps, see the diagram and parts list for all necessary parts. Cut protective plastic and peel away
from the stainless steel. Start on the Driver’s side.
2.
Remove the factory screws #7 & #8 on the wheel flare, as shown on the diagram and discard. Install one (1) sheet metal
screw #010017 and one (1) washer #018031 on hole #4 through previously, screw removed, hole #7. Loosely secure at
this point.
3.
Install one (1) sheet metal screw #010017 and one (1) washer #018032 on hole #5 through previously, screw removed,
hole #8. Loosely secure at this point.