Gateway KAS-303, System Manual

Page: 59 / 122

53
Surround sound
www.gateway.com
To adjust channel levels manually:
1
Press the
Ch. SEL
button on the remote control. Each time the button is
pressed, the corresponding channel is selected and displayed for several
seconds.
■
If the receiver is set to Stereo or Dolby Virtual mode or if the speaker
setting is set to
N
, center, surround L/R, surround back, or the
subwoofer channel cannot be selected.
■
If the headphones are connected, you can only select the front L/R
channel.
2
Press the
CH/LEVEL
up and down buttons on the remote control to adjust
the level of the selected channel.
3
Repeat Step 1 and Step 2 to adjust each channel level.
Storing channel levels in memory
You can store channel level settings in memory. This lets you change the
channel levels, then recall the stored settings.
To store channel levels in memory:
1
Press the
SETUP
button on the receiver for more than 2 seconds to enter
Setup mode.
2
While in Setup mode, repeatedly press the
SETUP
button on the receiver
until
P CALL
appears.
3
While displaying
P CALL
, press the
ADJUST
up and down buttons on the
receiver to select
P MEMORY
.
4
Press the
DECODING
button on the receiver to confirm.