Gateway GT5042j, Hardware Reference Manual

Page: 30 / 48

Replacing the heat sink and processor www.gateway.com
27
Important
Your computer hardware options and
port locations may vary from this
illustration.
3
Remove the three screws that secure the power supply to the computer.
4
Slide the power supply away from the back of the computer, then lift up.
5
Install the new power supply into the case, then install the three screws
to secure the power supply to the case.
6
Reconnect the power supply cables using your notes from Step 2 .
7
Replace the side panel by following the instructions in “Replacing the side
panel” on page 15 .
Replacing the heat sink and processor
Tips & Tricks
You need a Phillips screwdriver to replace
the heat sink.
To replace the heat sink and processor:
1
Remove the side panel by following the instructions in “Removing the side
panel” on page 12 .
2
For more stability, place your computer on its side. To avoid scratching the
case, place it on a towel or other non-abrasive surface.
Screws